Turn a cold water tap on to see what pressure is like. If there is no cold water pressure (& cold water should also stop running when turn on) – then cold water has been turned off when last person left (as should have been). Go to bottom RHS bathroom & there are 2 taps on wall next to toilet.
Top tap: water drain tap – turn fully to right until can’t turn any more – this closes it (stops water draining).
Bottom tap: water supply tap – turn this fully to left until can’t turn any more (turn hard to left as you may think can’t go any further) – so turn until you hear water
Turn on 2 power switches on bottom RHS wall (for hot water system & heating).
Slide knob to right (to full flame & uncoloured flame picture), hold & press ignition button for few seconds, then slide knob to picture of 3 full flames. (Just follow instructions on unit).
If ok you’ll see flame come on & system light.
Push down grey round knob (has #1 on top), sometimes doesn’t push right down – should push down to only few mm’s from base.
Then press ignition button (has #2 on) so pilot goes on.
Then turn thermostat to 65 degrees (can also adjust as required).
Slowly let #1 button release and system should light. (Instructions are also on unit).
Slide knob along to LHS to “off”. (Instructions are also on unit).
Turn off 2 power switches on bottom RHS wall (for hot water system & heating).
If ok you’ll see flame go out.
Turn thermostat to 0 degrees & turn off at switch on bottom RHS of wall.
If ok you’ll see flame go out.
Go to bottom rhs bathroom & there are 2 taps on wall next to toilet.
Top tap: water drain tap – turn fully to left until can’t turn any more – this opens it (let’s water drain).
Bottom tap: water supply tap – turn fully to right until can’t turn any more. This turns cold water flow off.
Empty perishables & turn off, and leave doors open.
Clean areas you have used.
Please advise secretary of any maintenance or other issues that were noticed.
Pay via Direct Funds Transfer to the Belmore Account as indicated on your invoice.